Spring corn harvest is at the time
Central Plains land operations busy
Zoomlion Corn Harvester
Help you harvest clean corn ears
To complete such high quality harvesting operations
You need to make professional adjustments to the peeling machine.
This issue will introduce
How to make professional adjustments to the peeling machine
Corn machine peeling machine adjustment
In order to ensure the best results of corn harvesting, the corn harvesting machine's stripping rate can reach 90-95% under normal conditions. It is not necessary to demand full stripping. Otherwise, the grain peeling phenomenon is easy to occur. The peeling machine should be based on the local corn ear. The diameter is adjusted: the diameter of the corn ear is large, and the gap between the press and the peeling roller needs to be increased. On the contrary, the gap is correspondingly reduced.
01, Adjusting the vibrating screen drive shaft The height of the two bearing seats is consistent with the plane on the frame to avoid inconsistencies such as distortion and deflection.
02, Check and adjust the factory state of the vibrating screen to a horizontal state; the vibrating screen bar and the vibrating screen plane are at an angle of -5°, and ensure that the four sets of sieve bars are consistent.
03, the rust of the reversing box clutch tooth pad will cause the clutch to open, and the rusted tooth pad should be lubricated for rust removal.
04, Adjust the size between the vibrating screen front baffle and the material curtain riveting to ensure 20mm.
05, Ensure that the top of the star wheel on the pressure feed shaft is about 40-45mm away from the surface of the stripping roller. The height of the pressure feed wheel is adjusted by the nut of the lifting rod of the lifting mechanism. When the amount of the ear is large and there is accumulation, the front group pressure should be Lift the shaft up and lift up to a maximum height of 75mm.
06, to ensure that the gap between the spring conduit and the baffle is 25~30mm. If the gap is too large, the pressure between the stripping rollers will accelerate the wear of the stripping roller and the peeling quality will be degraded. Therefore, the correctness of this gap should be checked frequently.
