|
The demo of the guest is updated again. This time we bring you the disassembly of OPPO Find X. If you don't say much, let's explore the secret of the dual-track predecessor structure. First, the back of the fuselage is heated, the glass back shell and the body are separated. It can be seen that there are many colloids on the inside of the back cover and the edge of the fuselage for fixing. After removing the back shell, we take out the slot of the fuselage. At this time, OPPO Find X is a state that can be directly disassembled. After removing the card slot from the bottom of the fuselage, it can be seen that it is arranged up and down, which has a certain saving effect on the space inside the fuselage. In addition, the red rubber ring on the edge enhances the waterproofness. Remove the screws under the fuselage, you can see the link screen, the motherboard's cable and coaxial cable arrangement is very dense. Close-up of the structure under the fuselage. Card slot portion under the fuselageWe return to the fuselage, remove the cover part, there is a groove for the movement of the coaxial line inside, and the foam part below is dustproof and cushioning. Since OPPO Find X uses a dual-track pre-existing structure, there is a coaxial connection in the part of the slide rail to ensure its normal sliding. Overall appearance of the fuselageRemove the cover of the coaxial part, you can see the whole picture inside the fuselage: It is still a three-stage design, but the camera part occupies a large part of the space. The part that is removed on the right side is the tablet above the motor. , has a certain buffer effect. Below the card slot is the sliding bracket on the left and right sides of the dual-track periscope structure. OPPO Find X has a battery capacity of 3730 mAh, which is very small, but has a high density and does not occupy much space inside the machine. Disassemble the screw on the top of the fuselage, you can remove the whole part of the camera. The structure is to connect the cable above the main board, and slide the track to realize the camera function. The upper part of the fuselage is close-up, the central part is the motor, which is used to power the lifting of the camera. The upper part of the metal part is tracked to support the sliding. We removed the motherboard, and the upper part (marked by the red box) is the cable that connects the two-track predecessor structure. The back of the main board is displayed, and the groove part in the middle is the movement space of the motor. Vibrator and speaker below the fuselage. The two-track periscope structure shows that the central circular groove is the rear double camera, and the upper part is the infrared sensor, the condenser sensor, the earpiece, the front camera, the dot matrix projector, etc. Rear dual-camera display, embedded together, placed in a two-track predatory structure. Disassembly reviewDisassembly score
|
