Everyone knows that water purifier products are different from previous household electrical appliances. It pays more attention to the maintenance and maintenance of the later period. These aspects are all right in order to make the water purifier's water purification effect the best and the life span longer. But the real life The water purifier is inevitably encountered some common faults. What should we do? Master repairs are still not necessary, some common glitches, and sometimes we only need to repair it with our own hands. Of course, this requires us to understand some of this knowledge.
1, the new machine water smell
After the water purifier is installed, the water purifier must be flushed first. The correct flushing method ensures the normal use in the later period. If the flushing sequence is wrong, more problems will occur, especially for the clean water mouthfeel. If the water purifier with ultrafiltration membrane is in the wrong order, the protective liquid in the ultrafiltration membrane will enter the rear activated carbon filter, and the protective liquid will affect the activated carbon filter, resulting in a poor feeling of the new machine outlet.
The outlet of the water purifier requires the installation of a food grade hose. If the hose material installed in the water purification outlet of the water purifier is not qualified, the rubber smell of the hose itself will change the taste of the water, which can also lead to poor drinking water. .
solution:
1) After the installation is completed, rinse the water purifier correctly and guide the user to use the method correctly.
2) Select food grade high quality hose when installing the water purifier to avoid unnecessary trouble.
2, joint leakage
Analysis of reasons: The water pressure is too large; improper operation. The probability of occurrence of general water machine is more.
Solution: Check the need for raw tape, pipe plugs, rubber gasket joints are complete and good.
3, ruptured membrane, carbon leakage, high or low water pressure
The water pressure of the water purifier is 0.1mpa-0.35mpa. If the water pressure is too low, it will affect the amount of water. If the water pressure is too high, it will cause membrane damage. Our common low-pressure switch leakage, leakage of activated carbon, activated carbon casing, super The rupture of the membrane shell is related to the excessive water pressure.
solution:
When installing the water purifier for the customer, before installation, the water pressure must be measured first to ensure that the water pressure is within the use range of the water purifier and the water pressure is too high. The user should communicate with the user and install a pressure reducing valve. The water pressure is too low. To advise the user to install a pressure pump.
4, The effect of purifying water is not obvious
The water source required by the water purifier is municipal tap water. If the water source handled by the water purifier does not meet the requirements of the quality of the incoming water, it will cause the phenomenon of poor water purification to occur. The water source used in many places is groundwater, and some places In the older communities, water pipes are galvanized. Because of the long time, the galvanized pipe is seriously aged, rusted, and the water source is muddy. In the case of water quality, it is recommended not to directly install the water purifier. In silt in water, rust can easily contaminate and block the filter element in the water purifier causing no effect of poor water or clean water.
solution:
Before the installation, the water pressure should be detected and the quality of the incoming water should be tested. If the water quality does not meet the requirements of the water intake, it is necessary to communicate with the user. It is recommended to install a pre-filter in front of the water purifier. If the user's home is used The water source is groundwater or reservoir water, and a prefilter must be installed in front of the water purifier.