The leakage of household water purifiers is a headache for consumers, and it is not a leaking wet floor or a bad floor, if the leakage downstairs can also cause tension in the neighbourhood.
So, what is the cause of leakage of household water purifier? How to avoid it?
First, the reasons for the leakage of household water purifiers are summarized as follows:
1, the quality of domestic water purifier itself Including the quality of household water purifier components, household water purifier assembly of fine, test pressure testing and quality inspection. Household water purifier parts are mainly connectors (connectors), according to consumers reflect the leakage of household water purifier is a lot of joint quality, not withstand pressure, not durable, not resistant to water hammer impact.
There is a connection to the use of PE pipe quality is very poor, concentricity is not good enough, uneven thickness of the pipe wall, not withstand pressure.
2, the water purifier is not properly installed.
The other reason for the leakage of household water purifiers may also be that the production workers are not properly connected to the internal parts of the household water purifier or the connection is not stable.
3, the joints are not tightened.
There is the water purifier installation process does not have the machine and the connection of the water pipe twist tight.
4, the appearance of the material quality of the tube is too poor
The appearance of the household water purifier tube material quality is too poor also can cause leakage.
Second, water purifier leakage Solution:
(a), Water outlet leakage: Due to the abrasion of the spindle gasket inside the faucet.
Use pliers to fasten the gland to loosen and remove, take the axis gasket out with the clamp, and replace the new axis gasket.
(b), faucet bolt lower gap leakage: That is due to the wear of a triangular gasket in the gland.
The screws can be loosened to remove the latch, then the gland is loosened and removed, and the inner triangular seal shop is removed and replaced with a new.
(iii) leakage at the junction of the nozzle:
Generally, the cap nut is loose and can be fastened to the cap nut or replaced with a new U-shaped gasket.
(iv) The amount of water becomes less:
May be the water leakage situation, because the single gun faucet of the disk stuck in the sand, this phenomenon or find a professional repairman dismantling the faucet cleaning, but if the rubber pad damage must be replaced. Now, the water purifier is almost a necessary product of family life.
But there are a lot of users to reflect on the use of water purifiers after a period of time, there is a slower situation, how to do? In order to fully filter the two pollutants in tap water, water purifiers do need a lot of ' patience ' and ' seriousness ' when they are filtered, so the water is not as big as the usual tap.
However, if the effluent situation is very small, then there is no need to worry, we can look for the following reasons:
Cleaning/replacing cartridge Generally speaking, the occurrence of water flow becomes smaller, commonly for the filter cartridge should be cleaned.
This is because the filter in the filtration of tap water, will be visible to the naked eye of the silt, rust, organic impurities and other pollutants in the filter surface, if a long time before cleaning/replacement, it is possible to make more pollutants heap, thus affecting the filtration speed.
Exhaust Air
Meet the problem of small water, you can first check whether the machine has air problems, if there is air to enter, you can try to exhaust the air.
Water pressure is not enough If there is no air problem, it may be because the water pressure is not enough, resulting in too little water.