|
Apple's sixth-generation iPad launched in the spring of 2018 has been dismantled by a foreign dismantling station, ifixit. This product is priced from 2,588 yuan. The internal structure and most of the parts are the same as previous generations; however, a large amount of glue is still used to bond. , so the repairability is very low. From the appearance point of view, there is no difference between the iPad of this generation and the spring of 2017, and they cannot be recognized together. Its opponents are Chromebook or Asus acer those low-cost notebooks. Dismantling begins, prior identificationThis is the back of the fuselage. By the way, with the X-ray look, the internal battery still accounts for most of the space. OK, take out the dismantling kitThe dismantling starts from the front and the glass is glued. Because it is a non-full-fitted screen, there is space between the glass and the liquid crystal layer. This visual effect is not as good as pro's full-fit screen, but it is cheap. Combined with its positioning, once it is broken by the students, it is easy to switch. The screwdriver will only be used afterwards, but it is just a few screws, and the rest is still glued in a lot of glue. Fortunately, the screen components are not sticky. There is a clip at the bottom of the screen. This structure is the same as last year's iPad. It can even be said that last year. It is now safe to disconnect the display section. The cable is different from the previous generation. We guess it is because this generation supports Apple Pencil. The main board is removed below, because the glue is glued on, first get the Sol agent up. So you can take it down. The Lightning connector is connected to the motherboard. This design is not good. Once it is broken, the entire motherboard has to be removed. The overall picture of the motherboard: A10 processor, 2GB RAM, and a configuration of the iPhone 7, but the touch part is the same as the iPad Pro, it may still support Apple Pencil's sake. In addition to the A10, other key originals are Red Toshiba's 32 GB flash memory, Orange is a Wi-Fi/Bluetooth module, Yellow is an NXP NXP80V18PN80V NFC master chip, and Green is a Cirrus audio codec chip; Parts are concentrated on this side, the back is quite concise. There is also this chip, NXP 8461A1, Touch ID fingerprint sensor sensor. The following is the battery, 32.9Wh capacity, exactly the same as the previous generation. But the battery life lasted 10 hours. Well, after the dismantling is completed, is it a very simple structure? To sum up: The overall structure and most of the parts of this generation of products are the same as the iPad 5, especially the battery. The replacement cost should not be high, but it has been improved in a few places. It just used too much glue to simplify the structure, resulting in demolition. The difficulty of recovering after opening increases a lot, so don't break it yourself.
|
