At present, the number of network-connected devices in the home is increasing. Smart TVs, smart refrigerators, smart air conditioners, smart speakers, and even smart toilet seats are all connected to Wi-Fi.
In this file, how can a Wi-Fi router drop? However, in reality, many smart devices have poor networking experience that cannot be covered by the wireless router signal, and there are Wi-Fi dead ends. The wireless corner of the apartment, the following "lu" (you) will help you.
Huawei child routing Q2
In the face of large size, duplex houses, villas and other complex structure housing, even if the procurement of high-end, and then expensive wireless router, 'a fist is also difficult for the four hands', I am afraid they can not achieve full coverage of Wi-Fi signals.
At this time, we must consider the use of wireless repeaters, power cats or distributed routing products. Now Huawei's daughter-and-child routing Q2, which was shown at the 2018 International Consumer Electronics Show (CES2018) earlier, has already started domestic pre-sale.
There are three advantages to child routing:
1, Wi-Fi seamless full coverage with power wiring
In principle, daughter-and-child routing is a set of home-level networking products that combine the common AC (controller) and AP (access point) control technologies and power line communication technologies of enterprise wireless networking. It can not only use the original power wiring in the home for network data communication, but also enable seamless roaming of Wi-Fi signals through AC and AP technology.
With the use of the original cable routing, users do not need to perform additional wiring operations. This effectively avoids the clutter of various cables and affects the aesthetics of the home improvement environment. In addition, wireless signals are also expanded to eliminate Wi-Fi dead angles. .
In other words, parent route=router+AC+power cat, sub-route=power cat+AP. In addition, on the parent route Q2, the wireless standard is also upgraded from 802.11n to 802.11ac, and the wireless rate is increased from 450Mbps to 1200Mbps.
2, Gigabit speed + full Gigabit Ethernet port
Huawei son-and-mother routing Q2 supports the latest G.hn Gigabit power line communication technology. The use of OFDM (Orthogonal Frequency Division Multiplexing) between the mother and the daughter can increase the maximum transmission rate to 1 Gbps to ensure high-speed network transmission. The mother routing network ports are also all in Gigabit level, which can meet the high-speed connection of wired devices in the room.
3, plug and play, simple and easy to use
Since Huawei's sub-parent route Q2 follows power line communication technology, the sub-route does not need any configuration, and only the parent route needs to be set, and which room signal is not good, the sub-route can be used by inserting the sub-route on the wall socket in the room. Access network.
It should be noted that the daughter-and-mother routing must be used within the same household and within the same meter (a common problem with power line communication equipment), and it is recommended to be away from high-power electrical appliances during deployment to prevent interference.
Child Routing Q2 Version
At present, Huawei's routed Q2 is divided into: 3 parental flagships, 1 mother and 2 sons, 1 mother and 1 son, sub-routing and other four versions. According to different packages, the price will be different, but you can It is estimated that the price of the 3 flagship mother's flag will be about 2200 yuan, while the 1 mother and 1 child will be about 1,000 yuan..
In general, a set of 1 tow 2 sub-matrix can be applied to the 4-5 room flat and duplex (up to 1 drag 15).
