As early as February 2017, Meizu debuted the third-generation fast charging technology 'Super mCharge' at the MWC 2017 Conference in Barcelona. The 11V5A high-voltage direct charge program with 55W power is rare on the market.
At present, the quick-charge solutions on the market are mainly divided into 'low-cost, high-voltage, high-voltage, small-current solutions' and 'high-cost, low-heat, low-voltage, high-current direct-charge solutions'. Meizu Super mCharge high-voltage direct charge is a combination of these two fast charge. The respective advantages of the program, high speed, high efficiency, high cost performance.
simply put, The Super mCharge reduces the differential pressure in series by means of a charge pump during charging. This high conversion rate of the charger's direct charge battery pack does not generate much heat. In normal use of the device, the battery pack is connected in parallel to the power supply output.
Super mCharge can be made into different power versions with different devices. The production version of the Meizu UP1020 is equipped with this kind of solution. The output power is 10V/2A/20W High pressure direct charge, Meizu E3 will soon be released with this charging scheme.
Today, through the Meizu UP1020 charger in advance to everyone bursts of drama about what the Super mCharge in the end.
Meizu mobile phone charger has a very good reputation in the player community, a few years ago UP0830, UP1220 because it also supports Qualcomm QC fast charge and MediaTek MTKPE fast charge two fast charge program is called artifact, many non-Mixed users also deliberately buy this This type of charger is used for multiple purposes. Can this UP1020 debut become another artifact?
In the picture, the darker color on the left hand side of the print is UP0830. The lighter on the right hand side is the protagonist UP1020. Both of them should use the same set of molds. The length, width and height are the same.
UP1020 measurements are as follows, width: 42.5mm * height 52.4mm * thickness 22.3mm, weight 52g, basically consistent with the UP0830 data.
The UP1020 still uses the USB-A output port, but after careful observation, the Meizu UP1020 adopts a custom USB socket. There are two contacts in front of the conventional 4-tab, which is somewhat similar to the low-voltage and high-current special socket of the OPPO. Is a high voltage direct charge OPPO is a low voltage direct charge.
Product nameplate parameters are as follows, Model: UP1020, Input: 100-240V~50-60Hz 0.7A, Output: 5V or 10V2A, Manufacturer: Shenzhen Sercon.
Take a look at the old artifact UP0830, use Power-Z FL001super protocol polling, from the screen to see can support QC2.0/QC3.0.
The old UP0830 recharged the Meizu M10 mobile power supply. The output was the MediaTek MTKPE fast charging protocol, which proved that the UP0830 was indeed a QC/MTKPE dual support.
It is then the turn of the protagonist UP1020, POWER-Z FL001super protocol polling that the UP1020 is completely uncomfortable with the fast-charging protocols currently on the market and does not support it.
UP1020 charges its own M10 mobile power supply, it can not trigger MTK fast charge, can only go 5V DCP mode. The conclusion is that UP1020 no longer supports Qualcomm QC, no longer supports MediaTek MTKPE, does not support other manufacturers' agreements, only supports their own special pins and wires Super mCharge.
