With the increasing demand for biomass fuel, more and more straw briquetting machine manufacturers, the quality of the biomass particle machine on the market is uneven. So, how to choose the biomass particle machine?
Select straw briquetting machine mainly to see the following aspects:
1. The appearance of quality straw briquetting machine casing surface spray should be uniform and firm, can not drain the paint, sagging and shedding. Chrome plated coating should be solid, bright polished surface, no off and rust stainless steel parts should be smooth, No knock bumps and should be processed with a neat polishing pattern.
2. Straw briquetting machine In addition to checking the body and the chassis, the motor (or diesel engine) and the chassis of the fastening situation, the ring mode particle machine to check the template fastening bolts tightened, and check the pressure roller bracket and the pressure roller Tightening situation.
3. Adjusting the gap between the mold and the pressure roller wall Make sure that there is no foreign matter in the shield and the ring mold, turn the ring mold by hand, then the spindle that is driven should turn briskly and there is no phenomenon of jamming and scratching.
4. Repeatedly open and close the ring molding warehouse door, test whether it is easy to switch, closed tight. The ring mold pressing chamber and powder feed cage junction sealing and lock reliability check with particular attention. The general requirement is : In place, the lock is firm, does not leak the powder material.Locking the warehouse door, the view from the side of the warehouse door seam sealing.If there is a sealed place, can be adjusted warehouse door hinge fixed Bolts make it possible to effectively prevent the leakage of powder.
5. Straw briquetting machine safety inspection. No matter what type of granulator drive, the transmission components such as: pulleys, drive shafts, flanges, etc., must be equipped with a special effective protective cover. This Protective cover requires a solid installation, which can effectively protect the operator's safety.
6. Test run the straw briquetting machine idling should not have irregular vibration, the gear of the percussion sound and feed the winch and agitator shaft rub. Particle machine after the normal test run, you can load test Run in powder feeding twisted cage appropriate amount of powder, observe the spindle motor current readings, so that the machine under test at a moderate load.
Finally, the finished product inspection. Straw briquetting machine particles should be smooth, section neat, can not have cracks. Have a certain surface hardness, it is difficult to crush the hand, while the finished product specifications should be uniform. Particle finished product pass rate can not Below 95%.
